P+F Pepperl+Fuchs Encoder Wonderful Industrial Control Dream in Rotation

The encoder wiring can be wired according to the manual and process requirements. The key is the mechanical speed of 6000 rpm. I am afraid your encoder will turn and smoke. At present, there is no such high speed encoder that can be connected to such a high speed. In general, the speed is reduced, and the gear ratio is low to measure the distance or speed. P+F Pepperl+Fuchs encoders are available from stock, welcome new and old friends to e-mail for consultation and purchase!

The rotary encoder can also get a speed signal, this signal needs to be fed back to the frequency converter to adjust the output data of the frequency converter. Trouble phenomenon: 1. When the rotary encoder is broken, the inverter cannot work normally, and the running speed becomes very slow, and after a while, the inverter protects and displays "PG disconnection" for the combined action to take effect. To make the electrical signal rise to a higher level and produce a square wave pulse without any interference, this must be processed by electronic circuits. Therefore, friends who need to purchase can rest assured. We mentioned above that the P+F Pepperl+Fuchs encoder will fail in the case of high magnetic field. Here is a solution for you. ① Eliminate the interference source; ② Determine whether it is the cumulative error of the mechanical gap; ③ Determine whether the circuit interface of the control system and the encoder does not match. The simple way to judge whether it is the fault of the encoder itself is the elimination method. The specific method of elimination is: replace it with an encoder of the same model. If the fault phenomenon is the same, the encoder fault can be basically eliminated.