Rotary encoder and motor connection steps2021

Some customers buy a rotary encoder to connect with the motor. The connection steps of the rotary encoder and the motor are roughly divided into four steps: determine the installation position, open the hole, install the connector, and do a good job of post-inspection. The specific details are as follows:

Encoder|Transmitter|Soft starter|Power supply|VFD|Light curtain|Servo products|Human-machine interface|Solenoid valve|Cylinder|Actuator|Flow meter|Transformer|Thyristor|Sensor|Deceleration drive gearbox reducer|Linear guide|Circuit breaker|Refrigeration compressorAll industrial products of okplazas are purchased from the original factory or formal channels of agents to ensure the original authenticity, which perfectly solves the problem of industrial product sample procurement and small-batch procurement for the majority of engineers and purchasing personnel.

1. Determine the installation location

The output shaft of the general type of motor is relatively short, so that after the pulley is installed, there is basically no place for the rotary encoder to install. Therefore, the installation position needs to be determined to ensure that the connector is limited in the later use. Quick action. When there is no place for the output shaft, the rotary encoder is usually installed in the second half of the encoder. As long as the position is accurate, the performance of the rotary encoder will not be affected;

2. Opening

After determining the installation position, the next step is to open the hole. Usually a transition hole is opened on the rear cover of the motor. In order to ensure the stable performance of the rotary encoder in the later use, it is necessary to install a transition shaft behind the motor. In addition, it is necessary to use an S-shaped steel sheet on the rear end cover of the motor for double fixing. Regarding the opening matters, the editor here also needs to remind everyone that the opening is based on the determination of the installation position, so in order to ensure the size of the opening and the close connection of the rotary encoder, it is necessary to maintain the axis of the two shafts. Relativity

Three, install the connector

In order to ensure the stability of the connection between the rotary encoder and the motor, a connector needs to be installed between the two. One side is connected to the motor and the other side is connected to the rotary encoder. The requirements for the selection of connectors are not very high. can use;

Four, check

After completing the above steps, the following is the important aftermath-inspection, but do not ignore the inspection link, the inspection can be large or small, for example, in the installation, the connection may not be reinforced due to carelessness. If there is looseness, it will inevitably affect the operation of later equipment.