ASCO analyzes the use of pneumatic cylinders

Cylinder is also an important part of pneumatic components. In order to ensure the normal operation of the cylinder and prevent unnecessary situations, today we will talk about the use of the cylinder in pneumatic components.

Encoder|Transmitter|Soft starter|Power supply|VFD|Light curtain|Servo products|Human-machine interface|Solenoid valve|Cylinder|Actuator|Flow meter|Transformer|Thyristor|Sensor|Deceleration drive gearbox reducer|Linear guide|Circuit breaker|Refrigeration compressorAll industrial products of okplazas are purchased from the original factory or formal channels of agents to ensure the original authenticity, which perfectly solves the problem of industrial product sample procurement and small-batch procurement for the majority of engineers and purchasing personnel.

When using gas cylinders, the air quality is very demanding. Clean and dry compressed air should be used. The air should not contain synthetic oils such as organic solvents, salt, and corrosive gases. , In order to prevent improper operation of the cylinder and valve. Before installation, the connecting pipes should be fully purged, and dust, debris, sealing tape fragments and other impurities should not be brought into the cylinder valve. Where there is a lot of dust, water droplets, and oil droplets, a retractable protective cover should be provided on the side of the rod, which should not be twisted during installation. Where the telescopic protective sleeve cannot be used, a cylinder with a strong dust-proof ring or a waterproof cylinder should be used.

　　The standard cylinder shall not be used in corrosive fog or fog that causes the expansion of the seal ring. The oil lubrication cylinder should be equipped with a reasonable flow oil mist injector. Oil lubrication of the cylinder is not allowed because the cylinder is pre-added with grease and can be used for a long time. This kind of cylinder can also be used to supply oil, but once the oil is supplied, the oil supply must not be stopped, because the pre-added grease may have been washed away, and failure of the oil supply will cause the cylinder to operate poorly.

Encoder|Transmitter|Soft starter|Power supply|VFD|Light curtain|Servo products|Human-machine interface|Solenoid valve|Cylinder|Actuator|Flow meter|Transformer|Thyristor|Sensor|Deceleration drive gearbox reducer|Linear guide|Circuit breaker|Refrigeration compressorAll industrial products of okplazas are purchased from the original factory or formal channels of agents to ensure the original authenticity, which perfectly solves the problem of industrial product sample procurement and small-batch procurement for the majority of engineers and purchasing personnel.

At the installation site of the cylinder, it is necessary to prevent chips from entering the air inlet of the cylinder. The cylinder cannot be used as a gas-liquid cylinder to prevent oil leakage. Do not damage the sliding parts of the cylinder and the piston rod to prevent air leakage caused by improper cylinder operation and damage to the piston rod seal. Appropriate maintenance and adjustment space should be reserved at the buffer valve, and proper installation and adjustment space should be reserved for the magnetic switch. If the cylinder is not used for a long time, it should be operated once a month and protected with oil to prevent rust.