How to install the encoder

Choosing a good encoder will be more effective in future working conditions! Better play the role of encoder! Today I will introduce how to install the encoder!

First choose the encoder. Be sure to choose the correct specifications. Different companies need different specifications of the encoder during the operation. Therefore, you must choose according to your own needs when purchasing. Don't try to buy a bunch of useless. of.

Before installation, check whether the encoder rotates flexibly, so that it can rotate flexibly and there is no noise. Secondly, wipe the encoder. The encoder must be dirty during placement, so wipe it clean before use.

Specific method: Wipe clean the tapered shaft of the encoder and the tapered hole where the spindle is installed with a clean fine cloth, and check whether there are burrs, raised high points, etc. at these two parts. If so, sand it with sandpaper, but do not operate on a large area, so as not to damage the mating surface of the cone. The last step is to hold the big end taper shaft in hand and push the encoder to make it tightly integrated. When doing this step, professionals suggest that you must pay attention to not too much force, avoid excessive torque, and prevent the inner hexagon from being screwed. Finally, tighten it and tighten the outer ring of the encoder at the same time. Try to see if it can be rotated by hand. If it does not indicate that the installation is firm, the installation is complete.