Pepperl + fuchs ultrasonic sensor output setting and ultrasonic sound cone width adjustment

To set the output mode of the Pepperl+Fuchs ultrasonic sensor and adjust the width of the ultrasonic sound cone, first press the A1 button and then power on. After power on, wait 1 second to ensure that the sensor enters the parameter setting mode and then release the A1 button. The green light flashes, it means the output mode is set, if the red light flashes at this time, it means the sound cone width is set. Press the A1 key to switch between output mode setting and sound cone width setting. In the output mode setting mode, press the A2 key to select the output mode. The flashing sequence of the green LED will change every time you press the key. The green LED-flash-off indicates that the longer the detection distance, the larger the output analog quantity; green LED flashes twice-off, indicating that the longer the detection distance, the smaller the output analog quantity; the green LED flashes three times and one off, indicating the zero line mode, generally not used, the smaller the output is selected; the green LED flashes three times and one off, indicating the zero line mode. After selecting the output mode, press the A1 button for 2 seconds to save the selected output mode, complete the parameter setting and ensure that the sensor returns to the standard mode.

Pepperl+Fuchs Ultrasonic is in the sound cone width setting mode, press the A2 key to select the sound cone width, the flashing sequence of the red LED will change after each key is pressed, the red LED flashes--off, indicating the width of the small sound cone and the detection width Small; green LED flashes twice-off, indicating medium sound cone width and detection width, green LED flashes three times-off, indicating loud sound cone width, detection width Z is large, after selecting the sound cone width, press the A1 key for 2 seconds Save the selected sound cone shape, complete the parameter settings and ensure that the sensor returns to standard mode. If the setting is not completed 5 minutes after entering the parameter setting mode, the sensor will not change any setting and exit the setting mode.